'V¥ ´ZûË´Gê­?if test ${boot_dev} = ""; then setenv boot_dev mmc; setenv root_dev /dev/mmcblk0p3; fi; if test ${boot_part} = ""; then setenv boot_part 0:1; fi; if test ${soc} = "kirkwood"; then setenv kernel_type kirkwood; else setenv kernel_type multi; fi; # Import uEnv txt... if fatload ${boot_dev} ${boot_part} ${kernel_addr_r} uEnv.txt; then echo Load uEnv.txt...; env import -t ${kernel_addr_r} ${filesize}; if test "${uenvcmd}" = ""; then echo ...; else echo Boot with uEnv.txt...; run uenvcmd; fi; fi; # for compatiblity reasons set DTBSUNXI if we run on sunxi if test "${board}" = "sunxi"; then setenv fdtfile ${DTBSUNXI}; fi; # Check if serial console is enabled if test "${SERIAL-CONSOLE}" = "ON"; then if test ${console} = ""; then if test "${board}" = "rpi"; then if test "${fdtfile}" = "bcm2837-rpi-3-b-plus.dtb"; then setenv console ttyS1,115200n8; else if test "${fdtfile}" = "bcm2837-rpi-3-b.dtb"; then setenv console ttyS1,115200n8; else setenv console ttyAMA0,115200n8; fi; fi; else setenv console ttyS0,115200n8; fi; fi echo Set console to ${console}; setenv bootargs console=${console} root=${root_dev} rootwait; else echo Set console to tty1 ; setenv bootargs console=tty1 root=${root_dev} rootwait; fi; setenv fdt_high ffffffff; fatload ${boot_dev} ${boot_part} ${kernel_addr_r} vmlinuz-${KVER}-ipfire-${kernel_type}; fatload ${boot_dev} ${boot_part} ${fdt_addr_r} dtb-${KVER}-ipfire-${kernel_type}/${fdtfile}; setenv ramdisk_addr ${ramdisk_addr_r} if fatload ${boot_dev} ${boot_part} ${ramdisk_addr} uInit-${KVER}-ipfire-${kernel_type}; then echo Ramdisk loaded...; else echo Ramdisk not loaded...; setenv ramdisk_addr -; fi ; bootz ${kernel_addr_r} ${ramdisk_addr} ${fdt_addr_r}; # Recompile with: # mkimage -C none -A arm -T script -d /boot/boot.cmd /boot/boot.scr